[. . . ] PART NO. 5659 / 5656 FORD F-150 WITH FACTORY FENDER FLARES FORD F-150 WITHOUT FACTORY FLARES AND WITH FACTORY RUNNING BOARD FRONT MUD GUARD INSTALLATION INSTRUCTIONS Install Paint Protection Film before mud guards (see other side) Please read instructions thoroughly before installation. Tools Required · 1/8" drill bit / Drill · Short #2 Phillips screwdriver · Center punch Package Contents Driver & passenger side rear mud guard #10 screw (qty. [. . . ] Clean and degrease the mud guard location area on the fender before installation. Attach mud guard to front fender with existing fasteners at locations B and C. Make sure bottom edge of mud guard is parallel to the ground before tightening fasteners. Using mud guard as a template, mark, center punch, and drill 1/8" holes at locations A and D. Attach mud guard to fender with #10 screws and washers at locations A and D. F-150 with flares F-150 without flares and with factory running board 5659_5656 Front Instr#1170E. doc Rev: 1 PART NO. PAINTING INSTRUCTIONS 1. Clean mud guard with a soap and water solution to remove dirt and other contaminates. PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS 5659 / 5656 NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner. Due to the rock guard on F-150 pickups without fender flares some trimming of the film template will be required for part no. Simply place film against fender in the mud guard contact area, place mud guard over film and mark where film needs to be trimmed away from plastic rock guard. [. . . ] Position the adhesive side of film on fender and flood with wetting solution. Allow film to dry before installing mud guard. 5659_5656 Front Instr#1170E. doc Rev: 1 [. . . ]